COBHAM SAILOR Fleet One Manual de instalación descargar pdf (Pagina 96)

Chapter 5: Configuration

98-141368-A 88

2. If you have installed a data connection switch, select Yes or No next to I/O control.

• Select Yes if you want the tracking function to follow the setting of the data control

switch, that is when the data control switch disables data, tracking is also disabled.

• Select No if you want the tracking function to be independent of the data control

switch.

For details on the use of a data connection switch, see To connect the data connection

status kit (optional) on page 32.

3. Type in the Server IP address, Server port, Client port and Encryption key for your

server connection.

• IP address. The IP address of the server that the SAILOR Fleet One will report to.

• Server port. Port number on the server. Default number is 7474.

• Client port. Port number on the SAILOR Fleet One terminal. Default number is 7475.

• Encryption key. A supplied 128 bit key which must match on both the client and

server side.

4. To allow remote control of the tracking settings from the tracking server, select Yes at

Allow remote control.

This means the SAILOR Fleet One terminal will accept commands from the specified

tracking server, for example to change reporting intervals or start/stop reporting.

5. Select the APN to use for Tracking. You have the following options:

• SIM default. The APN is taken from the SIM card. This is the recommended option,

unless you have special requirements.

• User defined. Type in the APN. APNs are provided from the Airtime Provider.

6. Under Position reports, select the report type you want to use.

• Compressed. Only latitude and longitude are reported.

• Extended. Apart from latitude and longitude, heading and altitude are also included.

• ECEF. The same information as Extended, but position and speed data are 3D (ECEF

coordinates).

7. Under Interval report, select Enabled or Disabled and type in the interval between the

reports.

8. Under Distance report, select Enabled or Disabled and type in the following:

•

When moved. Enter the distance the vessel should be moved before sending a report.

• Max one report per. Enter the minimum time that should pass between two reports.

Example: The distance is set to 1000 m and the time is set to 15 minutes. The

SAILOR Fleet One system has moved 1000 m since last report, but only 10

minutes have passed. A report will not be sent until the 15 minutes have

passed.

9. Click Apply.

1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 131 132

Sin comentarios

COBHAM SAILOR Fleet One Manual de instalación Pagina 96