COBHAM SAILOR Fleet One Manual de instalación descargar pdf (Pagina 35)

Chapter 2: Installation

98-141368-A 27

To connect a wireless LAN access point

The SAILOR Fleet One does not have a built-in wireless LAN (WLAN) access point. If you want

to use WLAN to access the SAILOR Fleet One you must connect an external WLAN access

point. The WLAN access point must be without NAT (Network Address Translation).

Connect a LAN cable between your WLAN access point and one of the LAN connectors on the

terminal.

Refer to the documentation for your WLAN access point for information on configuration.

To connect an IP handset to the LAN interface

To connect an IP handset to the terminal, do as follows:

Connect the cable from the IP handset to one of the LAN connectors on the terminal,

preferably port 1. In case of insufficient power to the LAN PoE the LAN ports are prioritised, so

that port 1 is the last to be shut down.

Note that the handset and terminal must be set up to be able to communicate with each other.

For further information, refer to Configuration for making calls on page 40 and the user

manual for the IP handset.

The maximum length of the cable between the IP handset and terminal is 80 m.

1. Both LAN interfaces can support devices of power class 1, 2 and 3 (4, 7 and 15.4 Watt), as long as

the total power consumption does not exceed 32 W. If the limit is exceeded, the LAN ports are

prioritised so that LAN port 1 has the highest priority and port 2 is closed down. In case of power

hold-up (failure on input power), PoE will be turned off completely.

Note

If you insert a switch or similar between the cradle and the terminal, or if you are

using a 3rd party IP handset, make sure that it conforms to the industry standard IEEE

802.3 af (using data pairs).

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 131 132

Sin comentarios

COBHAM SAILOR Fleet One Manual de instalación Pagina 35