
Chapter 2: Installation
98-141368-A 19
Mount the Basic cable support (optional)
If you want to use a cable support for your terminal, you can acquire a Basic cable support
(“Accessories kit F/ Terminal”, spare part no. S-673738A) from your distributor.
When mounted on the terminal the Basic cable support offers a number of holders to which
you can secure the cables from the terminal, using cable strips.
To mount the Basic cable support, do as follows:
1. Remove the two rubber washers from the bottom of the terminal at the connector panel
end. The threaded bushings underneath the rubber washers are used for mounting the
cable support.
2. Fasten the Basic cable support to the terminal using two M4 x 6 mm countersunk screws.
3. Install the terminal as described in To install the terminal on a bulkhead on page 20 or To
install the terminal on a desktop on page 20.
Comentarios a estos manuales