COBHAM SAILOR Fleet One Manual de instalación Pagina 43
- Pagina / 132
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 2: Installation
98-141368-A 35
Power cable recommendations
Overview
The terminal is delivered with a power cable, which can be extended according to the
recommendations in this section.
• When extending the power cable, positive and negative supply wires must be installed
closely together side by side to keep cable inductance low.
• Ensure that cable inductance for the selected cable at the desired length is below the
50 H requirement.
The power cable contains the following wires:
Calculating the maximum power cable extension
For 24 V DC operation, the total impedance must be max. 500 mOhm, including the source
impedance in the ship installation.
For 12 V DC operation, the total impedance must be max. 85 mOhm, including the source
impedance in the ship installation.
The total impedance is made up of the following:
• the source impedance in the ship installation
• the cable impedance of the supplied power cable, including the impedance in the joint of
the two cables. In the following example, the impedance of the cable and joint is set to
10 mOhm (1 m power cable). Note that if the cable length or type is changed, the
impedance will change accordingly.
• the extension cable impedance.
Colour of wire
in power cable
Pin number in
connector
Function
Red A1 Vin+
Black A2 Vin-
Black 1 not connected
Green 2 Remote on/off
Brown 3 not connected
Red 4 not connected
Orange 5 Remote on/off
- SAILOR Fleet One 1
- Disclaimer 2
- Trademark acknowledgements: 2
- Safety summary 1 3
- 98-141368-A iv 4
- Related documents 5
- Typography 5
- Table of contents 6
- Chapter 5 Configuration 7
- Chapter 1 9
- Introduction 9
- Features and interfaces 10
- Main units 11
- Tools for setup and use 12
- Available services 12
- Satellite coverage 13
- Chapter 2 14
- Installation 14
- Obstructions 15
- Radiation hazard 16
- Interference 16
- Radar distance 17
- 98-141368-A 10 18
- Antenna mast design 19
- Antenna mast length 20
- Install the antenna 21
- Important mounting notes 22
- Mount the antenna 23
- Where to place the terminal 24
- Install the terminal 25
- 98-141368-A 18 26
- 98-141368-A 19 27
- 98-141368-A 20 28
- Connect cables 29
- DC power input 30
- 98-141368-A 23 31
- To connect to the ignition 32
- Phone interface 33
- LAN interface 34
- 98-141368-A 27 35
- 12345678 36
- I/O pin functions 37
- 98-141368-A 32 40
- 98-141368-A 33 41
- Power cable selection 42
- Power cable recommendations 43
- 98-141368-A 36 44
- Chapter 3 45
- Get started 45
- Power up the SAILOR Fleet One 46
- Connect a smartphone 47
- 98-141368-A 40 48
- Connect an IP handset 49
- Connect an analogue phone 50
- Connect a computer 50
- Make a call 51
- Connect to the Internet 52
- Chapter 4 53
- Operation 53
- Call log 54
- To make local phone calls 55
- Dialling functions 56
- Data connection 57
- Physical connection options 58
- To access the Internet 58
- The built-in web interface 59
- Overview of the web interface 60
- To navigate the web interface 61
- Dashboard 62
- 98-141368-A 55 63
- 98-141368-A 56 64
- Phone book 65
- To edit the phone book 66
- SMS messages 68
- 98-141368-A 61 69
- To configure message settings 70
- Do you need a SIM PIN? 71
- To enter the SIM PIN 71
- 98-141368-A 64 72
- Wrong PIN 73
- Chapter 5 74
- Configuration 74
- Set up the data connection 75
- Set up the interfaces 76
- 98-141368-A 69 77
- 98-141368-A 70 78
- 98-141368-A 71 79
- 98-141368-A 72 80
- Select a preferred satellite 81
- Log on as administrator 82
- 98-141368-A 75 83
- 98-141368-A 76 84
- Save or load a configuration 85
- Call charges 86
- Log handling 87
- Data limits 87
- Configure the SIM PIN 88
- To change the PIN 89
- Set up user permissions 90
- Restricted dialling 91
- 98-141368-A 84 92
- External data connections 93
- 98-141368-A 86 94
- Track the SAILOR Fleet One 95
- 98-141368-A 88 96
- Antenna RF noise filter 97
- Chapter 6 98
- Update software 99
- 98-141368-A 92 100
- Part numbers 101
- Troubleshooting guide 102
- 98-141368-A 95 103
- Status signalling 104
- Generate a diagnostic report 105
- Event messages 106
- 98-141368-A 99 107
- 98-141368-A 100 108
- 98-141368-A 101 109
- 98-141368-A 102 110
- 98-141368-A 103 111
- 98-141368-A 104 112
- Extended status 113
- Antenna properties 113
- Self test 114
- Reset button 115
- 98-141368-A 108 116
- List of reserved subnets 117
- Appendix A 118
- Technical specifications 118
- Environmental specifications 119
- 98-141368-A 112 120
- Dimensions are in mm 121
- SAILOR Fleet One terminal 122
- 98-141368-A 115 123
- 98-141368-A 116 124
- Weight: 2.2 kg 125
- Glossary 126
- 98-141368-A 119 127
- 98-141368-A 120 128
- 98-141368-A 121 129
- 98-141368-A 122 130
- 98-141368-A 123 131
- 98-141368-A 124 132
© 2020, manymanuals.es. Todos los derechos reservados | 0.083 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales